Loohan Forums

This bulletin board is associated with the website loohan.com and its blog.
Anyone can read; just hit the Index tab. Permission is required to post. No agents need apply.
Posts in the wrong category will be relocated.

You are not logged in.

search engine by freefind advanced

#1 2016-03-19 20:42:35

ndw
Administrator
Registered: 2014-10-31
Posts: 720

Mar2015B weaponized

ok I was pouring some new mix, iron powder with xtals powder, and Loohan told me that the resin got Mar2015B and with this mix is more a weapon than the classical MarB.
so here it is smile

pendant%20mostly%20xtal_zpst6fwdehh.jpg

Offline

#2 2016-03-19 21:00:27

Loohan
Administrator
Registered: 2014-10-31
Posts: 8,019

Re: Mar2015B weaponized

Yeah, to me it feels more choppy and less soothing than MarB normally does. I think this would be good as a component in wands and used in cones for remote warfare on negative entities.
I get that the ring shape is not preferred for MarB if you use these ingredients.
Also i think sand (not bionized) plus iron oxide powder would work well for this effect. Some garnet sandblasting sand could even be included.
I haven't tried it yet.

[edit: actually i think bionized sand is OK here.]

Offline

#3 2016-03-29 18:45:24

Loohan
Administrator
Registered: 2014-10-31
Posts: 8,019

Re: Mar2015B weaponized

MarB-of-3.16.jpg

I used equal parts of my sandblasting "garnet sand" and granular ilmenite from a pottery supply store. As an afterthought i added 1/2 part bionized silica beach sand.

There is color variation because of the additives settling. Also i added a bit of activated charcoal to the top layer of the large pieces. Their bottom layer contains only shungite.

The brick contains a substantial device of taped quartz etc.
The cone contains only a quite small taped resin ring.
I lost the pics of those items when my camera card freaked out.
The cylinder has only the resin mix. It got 2 pours but you can see how the ingredients settled out.

It is real hard to improve on MarB by embedding anything. I have loads of stones, magnets, capacitors, wire, etc. etc. as well as about 3 cubic yards of various ugly taped-together items, but of all that, only these 2 items were synergistic at all.
Just the plain MarB pgm by itself is so top-notch, it is almost impossible to improve upon. So just pour some. Maybe throw in some bionized quartz if you want. If resin is expensive and quartzite common, i think one could incorporate a lot.

Also i made some TBs that included a couple layers of this stuff. I'll post a pic later.

The garnet/ilmenite mix also weaponizes the MarB pgm well. Like what ndw did, it gives it more bite into evil.

Offline

#4 2016-03-31 14:28:41

Loohan
Administrator
Registered: 2014-10-31
Posts: 8,019

Re: Mar2015B weaponized

Some of the TBs:

TBs.3.16.jpg

Only the bottom and top layers have this pgm and powder mix. But again, each MarB layer separated into a powder-dense and powder-lite layer.
The TBs feel pretty groovy.

Offline

Board footer

Powered by FluxBB